PTP microwave wireless bridge （Remote Terminal)

                                W500MW microwave transmission device is independently developed by FELICOMM, it connects to service devices through 

                                SFP+/10Gbps ports, no need to install footprint, reduces network deployment costs.

                                Main Features

                                ●MIMO 8*8, point to point or point to multi-points connect available

                                ●POE support

                                ●Ultra-broadband, 160MHz band width support, up to 10Gbps throughput.

                                ●TDMA technology, avoid inter-symbol interference.

                                ●Outdoor design, IP67 weatherproof, 10KV lightning protection, can work in harsh environment range from -40℃ to 85℃.

                                With the development of telecommunication technology, optical fiber has been widely applied in network deployment, 

                                however, high cost, long built-in lead time, difficulties of way right acquisition, complex landform, make optical fiber network 

                                deployment impossible at sometimes, and Felicomm independently developed microwave wireless bridge W500MW can 

                                solve these problems, makes full network coverage easily.

                                Scenarios of W500MW application:

                                ★Backhaul 5G from BBU to PTNs

                                W500MW is capable of up to 5Gbps can accommodate bandwidth requirements, its broad band width and low latency can 

                                complete optical fiber network for last mile, or serve as a replacement in where optical fiber network is difficult to deploy.

                                ★Transmission between bus and station

                                Microwave wireless bridge W500MW is also a common solution for data transmission between bus and bus station. 

                                Traditional method of bus monitor data transfer is kept in NVR first and downloaded manually after work, it’s time consuming 

                                and error prone. 

                                Now, you can mount 1pc W500MW in bus and 1pc W500MW in bus station, the monitor data can transmission to center PC 

                                every time when bus stopped at each bus station, easy for timely checking and greatly improved work efficiency.